Dev Group · Rubik Pro العربية

Rubik 3×3 · 3 / 7

Complete the first-layer corners

Choose a white corner with the exact other two colors of its intended slot. These three colors identify its home.

1/3

Keep the white plus sign underneath

Choose a white corner with the exact other two colors of its intended slot. These three colors identify its home.

2/3

Position the corner above its place

Rotate U to place the target corner at the front-right-top, above its home. Keep the chosen front face unchanged.

3/3

Repeat the right-hand trigger if necessary

Use R U R′ U′, then inspect. It can take several repeats depending on orientation. An incorrectly installed corner can first be moved to the top.

Algorithms in this lesson

Important: this simulator starts with a prepared example case that needs these moves, NOT a solved cube. Use Next to watch each real layer turn toward the result. Your own cube's case and required setup may differ.

The prepared simulation illustrates a specific training case; it is not a universally solved starting cube. Clockwise is defined while looking directly at the moving face.

Right-hand trigger

R U R' U'

← Previous Next lesson →

Reasoning and guided practice

A corner belongs to three faces. Before inserting it into the first layer, identify the three center colors corresponding to its correct slot.

If the target corner is above the slot, use a short insertion while watching whether the white cross stays intact. If you disrupt solved edges, undo the move and reorient the cube.

Understand the reasoning behind this lesson

Find the correct corner before turning

For each bottom corner, identify its three colors. The target slot sits between the corresponding three center colors, not simply where white happens to point.

Put the unsolved corner above its target, maintain white on D, then use a short corner insertion sequence without disturbing solved blocks.

Prove the first layer is truly solved

All nine white stickers should face down and the bottom rows of all four side faces should match their centers.

A white-looking face with two neighboring stickers swapped is not a correctly solved first layer.

Extra written explanations and mistakes to avoid

Three colors determine a home

A white-red-blue corner belongs where white, red and blue centers meet. If the top-layer candidate has white, red and green instead, it must go to a different slot even when its white sticker appears conveniently oriented. Distinguish choosing the right piece from turning that piece into the right orientation.

Prepare the corner before triggering

Keep the correctly aligned white cross underneath. Locate the target corner and rotate U to place it above its corresponding slot. With the guide's intended front/right position established, perform the shown trigger slowly and inspect the result. Repeating it while holding a different front face may affect other pieces instead.

Check a full layer

After placing the corner, verify its white sticker and both side colors. Correct the other corners only after you can explain each move and confirm the previously solved white edges remain aligned. If the cross is broken at the end, review your setup or restore a known cube state rather than blindly continuing.